To Next Page

To Previous Page

Return parameter:<NRf>

[SOURce:]VOLTage:PROTection:DELay

This command is used to set the software-voltage protection delay time.

Command syntax：[SOURce:]VOLTage:PROTection:DELay<NRf>

parameter：0.001~0.6

unit：s

inquiry syntax：[SOURce:]VOLTage:PROTection:DELay？

Parameter：0.001~0.6

Return parameter：<NRf>

[SOURce:]VOLTage:PROTection:STATe

This command is used to set the software-voltage protection state.

Command syntax：[SOURce:]VOLTage:PROTection:STATe<bool>

parameter：0|1|ON|OFF

inquiry syntax：[SOURce:]VOLTage:PROTection:STATe？

parameter：None

return parameter：0|1

[SOURce:]VOLTage:PROTection:TRIGgered?

This command is used to inquire the executing state of over voltage protection.If return

“1”,this indicates the OVP circuit has been triggered and the OVP state does not be cleared.If

return “0”,which means OVP circuit is not be triggered.

Command syntax：[SOURce:]VOLTage:PROTection:TRIGgered?

Return value：0|1

[SOURce:]VOLTage:PROTection:CLEar

This command is used to clear the OVP state.Before sending this command,please increase

the upper limitation of OVP or you can also reduce the output voltage.

Note:Please remove the external power supply which caused this protection and then send

this command.

ITech IT6512 Programming Guide

Other manuals for ITech IT6512