Remote Operation Mode
Copyright © Itech Electronics Co., Ltd. 47
5.4 GPIB interface
First, Connect the GPIB interface on the power supply and the GPIB card on
computer via IEEE488 bus, must be full access and tighten the screws. Then
set the address, the address range of the power : 0 to 30, can set by the
function key on the front panel, press the (Shift)+ key to enter the
system menu function, find the GPIB address setting by button, type the
address, key to confirm. GPIB address is stored in nonvolatile memory
line.
To Next Page
Loading...
