Enquire the current lower limit in CV mode
Set the voltage upper limit in CP mode
Enquire the voltage upper limit in CP mode
Set the voltage lower limit in CP mode
Enquire the voltage lower limit in CP mode
Set the max input resistance
Enquire the max input resistance
Set the voltage upper limit in CR mode
Enquire the voltage upper limit in CR mode
Set the voltage lower limit in CR mode
Enquire the voltage lower limit in CR mode
Set the current range in list mode
Enquire the current range in list mode
Set step counts of autotest file
Enquire step counts of autotest file
Set the on-load time of single step
Enquire the on-load time of single step
Set the delay time of single step
Enquire the delay time of single step
Set the no-load time of single step
Enquire the no-load time of single step
Set autotest stop condition
Enquire autotest stop condition
Enquire autotest chain file
If control output of electronic through PC, please setting electronic load to PC control state.
Command is 20H.
4． From 4
th
byte to 25
th
byte are information contents.
5． 26
th
is checksum code, is the sum of the former 25 bytes.
To Next Page
Loading...
Need help?
General
