ITech IT8511A+ - Chapter 3 Functions and Characteristics; Local Mode;Remote Mode; Operation Mode

29
From 8
th
to 25
th
byte
Syetem reserve
26
th
byte
Sum code
61. Set/Enquire the current range in list mode.( C6H/C7H)
1
st
byte
Start bit ( AAH )
2
th
byte
Address (0—31,0XFF)
3
th
byte
Command（C6H/C7H）
From 4
th
to 7
th
byte
Current range (Lower bytes are in the former location, higher bytes
are in the later location)
From 8
th
to 25
th
byte
Syetem reserve
26
th
byte
Sum code
62. Set/Enquire autotest steps.( D0H/D1H)
1
st
byte
Start bit ( AAH )
2
th
byte
Address (0—31,0XFF)
3
th
byte
Command (D0H/D1H）
From 4
th
to 5
th
byte
Autotest steps (Lower bytes are in the former location, higher bytes
are in the later location),when one step is selected,then
corresponding bit should be set to 1.
From 6
th
to 25
th
byte
System reserve
26
th
byte
Sum code
63. Set/Enquire Short steps.( D2H/D3H)
1
st
byte
Start bit ( AAH )
2
th
byte
Address (0—31,0XFF)
3
th
byte
Command (D2H/D3H）
From 4
th
to 5
th
byte
Autotest short steps (Lower bytes are in the former location, higher
bytes are in the later location),if one step is set to short on
mode,then this bit should be set to 1
From 6
th
to 25
th
byte
System reserve
26
th
byte
Sum code
64. Set/Enquire Pause steps.（D4H/D5H）
1
st
byte
Start bit ( AAH )
2
th
byte
Address (0—31,0XFF)
3
th
byte
Command (D4H/D5H）
From 4
th
to 5
th
byte
Autotest Pause steps (Lower bytes are in the former location,
higher bytes are in the later location),if one step need to pause,then
this bit should be set to 1
From 6
th
to 25
th
byte
System reserve