ITech IT8722 Programming Guide

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 65
Chapter10 SOURce Subsystem
These commands control the input of the electronic load. The INPut and
OUTput commands are equivalent. The CURRent, RESistance and VOLTage
commands program the actual input current, resistance, and voltage.
[SOURce:]INPut:ALL
These commands enable or disable all models inputs. The state of a disabled
input is a high impedance condition.
Command Syntax
[SOURce:]INPut:ALL[:STATe] <bool>
Parameters
0 | 1 | OFF | ON
Examples
INP:ALL 1
[SOURce:]INPut
These commands enable or disable the electronic load inputs. The state of a
disabled input is a high impedance condition.
Command Syntax
[SOURce:]INPut[:STATe] <bool>
Parameters
0 | 1 | OFF | ON
*RST Value
OFF
Examples
INP 1
Query Syntax
INPut[:STATe]?

ITech IT8722 Specifications

General

Brand	ITech
Model	IT8722
Category	Test Equipment
Language	English