ITech IT8800 Series Programming Guide

Measure Commands
Copyright © ITECH Electronic Co., Ltd. 31
Chapter6 Measure Commands
This signal measure command is used to get the read back value. You can use
this high level command to control the measurement process.
FETCh:VOLTage[:DC]?
This command returns the last measured input voltage stored in the
communications buffer of the electronic load. A new measurement is not
initiated by this command.
Group
Measurement
Syntax
FETCh:VOLTage[:DC]?
Returns
<NR2> is the measured input voltage in volts.
Example
FETC:VOLT? might return 5.0011, which would be the
measured voltage across the electronic load inputs in volts.
FETCh:VOLTage:MAX?
This command returns the last measured input maximum voltage stored in the
communications buffer of the electronic load. A new measurement is not
initiated by this command.
Group
Measurement
Syntax
FETCh:VOLTage:MAX?
Returns
<NR2> is the measured input maximum voltage in volts.
Example
FETC:VOLT:MAX? might return 100.0011, which
would be the measured maximum voltage across the
electronic load inputs in volts.
FETCh:VOLTage:MIN?
This command returns the last measured input minimum voltage stored in the
communications buffer of the electronic load. A new measurement is not
initiated by this command.
Group
Measurement
Syntax
FETCh:VOLTage:MIN?
Returns
<NR2> is the measured input minimum voltage in volts.

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English