ITech IT8800 Series Programming Guide

Error Information
Copyright © ITECH Electronic Co., Ltd. 64
Chapter13 Error Information
Error Number List
This appendix describes the error numbers and descriptions that are returned
by the electronic load. Error numbers are returned on the front panel in two
ways:
 Error number with messages after the SYSTem:ERRor? query
 Error number with an NR1 and a string after the SYSTem:ERRor? query
Errors from 100 to 199 (Set bit #5 of standard event status register) are explained
as follows.
(0) No error
(101) DESIGN ERROR: Too many numeric suffices in Command Spec
(110) No Input Command to parse
(114) Numeric suffix is invalid value
(116) Invalid value in numeric or channel list, e.g. out of range
(117) Invalid number of dimensions in a channel list
(120) Parameter overflowed
(130) Wrong units for parameter
(140) Wrong type of parameter(s)
(150) Wrong number of parameters
(160) Unmatched quotation mark (single/double) in parameters
(165) Unmatched bracket
(170) Command keywords were not recognized
(180) No entry in list to retrieve (number list or channel list)
(190) Too many dimensions in entry to be returned in parameters
(191) Too many char
(-150) String data error
(-151) Invalid string data [e.g., END received before close quote]
(-158) String data not allowed
(-160) Block data error
(-161) Invalid block data [e.g., END received before length satisfied]
(–168) Block data not allowed
(-170) Expression error
(-171) Invalid expression
(-178) Expression data not allowed
Execute errors from -200 to -299 (Set bit #4 of standard event register) are
explained as follows.
(-200) Execution error [generic]
(-221) Settings conflict [check current device state]
(-222) Data out of range [e.g., too large for this device]
(-223) Too much data [out of memory; block, string, or expression too long]
(-224) Illegal parameter value [device-specific]

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English