ITECHWORLD 30A BATTERY CHARGER
USER GUIDE
Connect the charger positive battery clamp to the iTECH120X
positive terminal and the negative battery clamp to the negative
terminal, then turn on the battery charger. The battery charger
may not start charging when turned on, this would be indicated
on the charger by only a Green led illuminating and the
ammeter on 0 proceed to step 2 if this is the case.
1.
The iTECH120X can also be reset with our 30Amp battery charger by
following the steps below. You can purchase out 30Amp battery
charger here: https://bit.ly/itech30abc
To Next Page
Loading...
