The iTECH120X has numerous safety features pre-installed inside
the battery to make it the safest lithium battery available in
Australia. Once such feature is "safe mode". If you draw too
much power from your battery (over discharge) your iTECH120X
battery will enter safe mode to protect itself. The iTECH120X will
enter safe mode at a voltage of 9v or less, the terminals have
been shorted or too much current has been drawn. Once the
battery is in safe mode it will appear to be open circuit. No
voltage( or a low voltage) will be detected on the battery
terminals and there will be no current output. There are
numerous ways to bring your iTECH120X battery out of safe
mode, such as using jumper cables, our iTECH2000A jump
starter, iTechworld 30 Amp battery charger and the iTechworld
Lithium bypass cable, each method will be explained in the
following pages.
SAFE MODE
USER GUIDE
To Next Page
Loading...
