Itho Daalderop Mono - Product Information; Application

2. Product information
2.1. Application
The Electric storage water heater is a hot water heater designed for use in the kitchen, shower and/or bath.
The water heater operates completely independently and is not connected to a boiler. This water heater heats the water using electricity
instead of gas. The water heater is capable of supplying a comfortable flow of hot water to multiple tap points simultaneously.
The water heater is equipped with a copper inner tank.
Itho Daalderop offers a variety of different electric storage water heaters.
The right choice of model depends on average hot water consumption and the power supply.
Mono
The Mono is a low-power water heater with one heating element
and is suitable for consistent daily hot water consumption.
By preference, heating is done using off-peak tariff electricity
(variable rate plan). To switch on the water heater during off-peak
hours, an external device such as a timer is required.
Mono-plus
The Mono-plus is a low-power water heater with two heating
elements and is suitable for hot water consumption that is
normally variable.
The stored water is maintained at the same temperature
throughout the day.
By preference, heating is done using single tariff electricity.
Mono-3
The Mono-3 is a high-power water heater with three heating
elements and is suitable for highly variable hot water
consumption by large consumers such as hospitality
establishments and sports clubs.
The stored water is maintained at the same temperature
throughout the day.
By preference, heating is done using single tariff electricity.
Duo
The Duo is a low-power water heater with two heating elements
and is suitable for variable hot water consumption.
By preference, heating is done using off-peak tariff electricity
(variable rate plan). To switch on the water heater during off-peak
hours, an external device such as a timer is required.
The internal boost timer can be used to heat the stored water
once additionally during peak hours (variable rate electricity
tariff) for a maximum of 120 minutes.
The heater can be connected in one of the following ways:
● Water pressure principle with safety group.
This connection method is described in this manual.
● Water pressure principle with safety mixer tap.
See the installation instructions for the safety mixer tap.
● Low pressure principle with special low pressure mixer tap.
See the installation instructions for the low-pressure mixer tap.
7