HMPRO35 OPERATOR’S MANUAL
7 www.itmtools.com.au
TRADEMASTER
Magnetic Base Drilling Machines
Tools and Machinery
AIR
20. Use the safety strap in all operating positions. Attach the machine to a fixed
structure by fastening the strap through the opening in the machine body or to
the carrying handle when working in horizontal position. Never insert the strap
into the buckle from the front.
21. Before every use, inspect the machine to ensure it is not damaged. Check
whether any part is cracked or improperly fitted. Make sure to maintain proper
conditions that may affect the operation of the machine.
22. Always use eye and hearing protection as well as protective clothing during
operation. Do not wear loose clothing.
23. Proceed with caution when drilling in plates with a thickness less than 10 mm
because the holding force depends on material thickness and is significantly
lower for thin plates.
24. The entire bottom of the electromagnetic base must be in full contact with the
workpiece. Before every positioning, wipe the workpiece with coarse-grained
sandpaper.
25. Do not touch moving parts or chips formed during cutting. Prevent objects
from being caught in moving parts.
26. After every use, remove metal chips and excess coolant from the machine
and tool. Do not remove chips with bare hands.
27. Cover steel parts with a thin anti-corrosion coating to protect the machine
from rust when not in use for any extended period.
28. Maintain the machine and install/remove parts and tools only when the
machine is unplugged from the power source.
29. Repair only in a service centre appointed by the seller.
30. If the machine falls from any height, is wet, or has any other damage that
could affect the technical state of the machine, stop the operation and
immediately send the machine to the service centre for inspection and repair.
31. Never leave the machine unattended during operation.
32. Remove from the worksite and store in a secure and dry location when not in
use, removing the cutter and pilot pin from the arbor.
To Next Page
Loading...