IMPORTANT SAFETY INFORMATION
WARNING ENTANGLEMENT HAZARD
Do not operate this tool while wearing loose fitting clothing.
Put up long hair and keep it away from the unit.
Keep hands away from moving objects or anything that can pinch
or crush a hand or body part.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN
SEVERE INJURY OR DEATH.
WARNING - TIPPING HAZARDS
Always be aware of your surroundings. Keep unit on even ground and
ensure weight is always evenly distributed. Maintain a safe distance from
the unit when in transit.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN
SEVERE INJURY OR DEATH.
WARNING - TOOL USE HAZARDS
Use this tool for manufacturer’s intended purpose only. Use of the
product other than that which is described in this manual can result in
injury or property damage.
Inspect all aspects of wire pulls to ensure safety. Including cable pullers,
booms, sheaves, rope, swivels, pins, etc. and replace any defective
components BEFORE you proceed.
Always inspect the structural integrity of any supports, conduit, anchoring
system, etc. that will be used to hold wire pullers during pulls. These
supports should be able to withstand the maximum pulling force of the
cable puller plus a safety factor of 3:1. A 12,000 lb./5,442 kg. wire puller should
be anchored to a support that can withstand the force of a 36,000 lb./16,327 kg.
pull. Only qualified personnel should use pulling equipment.
Do not use cable pullers as a hoist or winch. Cable pullers cannot lower
a load and may fall causing serious injury or death.
Do not exceed the load rating of any cable puller, rope or accessories in use.
Always plug into a grounded receptacle with a 20 amp CGFI protected circuit.
Do not modify the provided plug. Always disconnect cable pullers and other
equipment before servicing.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE INJURY
OR DEATH.
Page 6
To Next Page
Loading...