IMPORTANT SAFETY INFORMATION
WARNING - TOOL USE HAZARDS (CONTINUED)
Do not operate cable pullers in wet or damp locations.
Do not expose to rain.
Do not operate in an explosive atmosphere.
Some components of cable pulling packages can exceed 50 lb./23 kg.
and will require more than one person to lift, transport or assemble.
Always inspect pins to be sure they are the correct part for the assembly
and are fully inserted through the unit and have spring clips properly attached.
Do not substitute any other object for factory supplied pins.
When making a vertical pull, keep the area underneath the cable puller clear
of all personnel.
Use caution during assembly and disassembly of pulling setups.
Keep pins and bolts in place to avoid uncontrolled movement.
Do not switch between low and high speeds while foot pedal is depressed.
Always make sure the puller has completely
stopped before switching from low to high speed or high to low speed.
DO NOT ALTER CABLE PULLING EQUIPMENT OR ANY EQUIPMENT
BOUGHT FROM iTOOLco. Doing so will VOID YOUR WARRANTY.
Guards, testing, and safety features are provided for your protection.
Do not use an extension cord longer than 100 ft./305 cm. Extension
cords should be a minimum of 12 gauge wire with ground.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE
INJURY OR DEATH.
Page 7
To Next Page