iTrue X3 - Charging the Battery

19
Getting Star ted
Installation of your X3 HD Digital Roadcorder
TM
Charging the battery
Use the charger to charge the battery before using it for the first time. Charge
the device by connecting front camera via the USB car charger. Use only
our approval chargers, batteries, and cables. Unapproved chargers or
cables can cause the battery to explode or damage the device.
Connect the USB car charger’s jack to the USB char ging port and then
plug the charger into the car cigarette lighter socket.
· When device detects no power supply, it will automatically switch off in 5
seconds time. To turn on the device again, you will need to press on the
on/ off button to manually switch it on.
· If the battery is completely discharged, the device cannot be turned on
immediately when the charger is connected. Allow a depleted battery to
charge for a few minutes before turning on the device.
Connecting the charger improperly may cause serious damage to the
device. Any damage cause d by misuse is not covered by the warranty.
· The device can be used while it is charging, but it may take longer to fully
charge the battery.
· If the device receives an unstable power supply while charging, the
screen may not function. If this happens, unplug the charger from the
device.
· While charging, the device may heat up. This is normal and should not
affect the device’s lifespan or performance.
· If the device is not charging properly, take the device and the charger to a
our Service Centre.