2
Power Units (All Potted Models)
5200095 Rev C
2. INTRODUCTION
NOTE – Simco-Ion recommends that these instructions be read completely before
installation or operation of this equipment. Failure to do so could result in personal
injury and/or damage to the equipment.
The Simco-Ion Power Unit provides a high voltage output for powering various types of
Simco-Ion static eliminating equipment. Although there are many individual models, all
are basically the same with respect to mounting, connections, and operation. These power
units are potted in a metallic enclosure and require no maintenance or adjustments.
Each power unit operates on a specific line voltage and frequency and provides a specific
high voltage output. The power unit supplied is based on the type of static eliminating
equipment it is powering. The power unit must only be used with the equipment for
which it was originally supplied. Do not add any other device to the power unit without
consulting Simco-Ion.
Technical Assistance
Simco-Ion Customer Service provides technical support such as diagrams and replacement
parts lists upon request. Contact information is listed on the back cover of this instruction
manual.
Receipt of Equipment
1. Carefully remove equipment from the carton.
2. Inspect contents for damage that may have occurred during shipment. If any damage
has occurred during shipment, the local carrier should be notified at once. A report
should be forwarded to Simco-Ion, 2257 North Penn Road, Hatfield, PA 19440.
3. Empty the carton to insure that small parts are not discarded.
Return Shipments
Prior to returning goods, contact Simco-Ion Customer Service representative for a
Return Authorization Number. This number should be included on the packing list. All
correspondence should also reference the Return Authorization Number. Any item being
returned should be shipped prepaid and packed to provide adequate protection.
To Next Page
Loading...
