After the measurements, if the following buttons are pressed, each LED in the button④
lights and each measured data will be displayed. As the LED in IB button lights, if +
()DECAY button or -DECAY button is pressed, the maximum voltage peak value
or the minimum voltage valley value of ion balance will be displayed. Press IB()
button once again and press +DECAY or -DECAY button to be displayed the decay
timedataagain.
()a
()d
() ()bc
() () ()a Measurement end e f
b +DECAY button red : Positive decay time() ( )
c -DECAY button green : Negative decay time() ( )
d IB button yellow : Average voltage of ion balance() ( )
() ( ) ( )e +DECAY button red : Maximum voltage of ion balance peak value
() ( ) ( )f -DECAY button green : Minimum voltage of ion balance valley value
LCD display for measured data
Press SAVE button black to save measured data into internal memory. At this⑤()
time, the number of preserved data is shown on the display. The numerical value
increases by 1 whenever the data is saved.
The number of saved data
PressMODEbuttontoreturntoautomode Au .PressPLATECONTROLbutton⑥()
to measure again if needed.
-page29-
To Next Page
Loading...