Section 8. Saved data copy
8.1 Cable connections
The saved data in auto mode can be copied in CSV or TXT format by connecting①
EA-5J with a personal computer. Prepare a USB cable USB A - USB Mini-B .(() ( ))
Connect USB Mini-B of the cable to a USB terminal on the EA-5J and connect()
the USB A to the computer.()
CAUTION
Windows 2000 or later operating system is required for this saved data copy.It
cannot be done by earlier operating system.
Turn on the power of EA-5J with connecting the plate sensor CPM-LPS .②()
8.2 Setup of the computer
Turn on the power of the computer. If there is no USB driver in the computer, it①
may request to install the driver. In this case, install the USB driver properly.
Load a Window's software "Hyper Terminal"②
in the computer. It can be found by clicking in
"Start" - "Program" -the following order.
"Accessories" - "Communication" - "Hyper
Terminal".
At the first time, the computer shows "New connection" as shown below. Input③
suitable name, chose Icon as you like and click "OK" button.
-page30-
To Next Page
Loading...