ITW Simco-Ion EA-5J - Section 9. Tables of Functions

Section 9. Tables of functions
9.1 Button switches
Character Operations Unit Additional
color character()
()POWER Ready to start when power on
Blue Measurement stop or compulsion end after Non Non()
power on
MODE Mode can be changed whenever the button is Non Non
White pressed. Manual, PC and Auto()
IB Yellow Ion balance measurement in manual mode V IB()
Positive decay time measurement in manual
+DECAY mode kV, V, IB,
Red Indication of the maximum voltage after ion s HOLD()
balance measurement
Negative decay time measurement in manual
-DECAY mode kV, V, IB,
Green Indication of the minimum voltage after ion s HOLD()
balance measurement
SAVE Black Measured data saving in auto mode Non Non()
PLATE CONTROL Start measurement in each mode kV, V, IB,
Red Stop continuous measurement in ion balance s HOLD()
mode
9.2 Function switches
Character of switches Operation
SET Alteration or saving the measurement condition setting
DOWN or UP Alteration of the setting point
RESET Deletion of saved data in EA-5J
9.3Beepsounds
[] [ ]Once, Pi , 0.25 seconds Continuous, Piii
Power ON Measurement end in manual mode or auto mode Measuring range exceeded
9.4 Lighting of LEDs
LED HV OUT GND CHARGE In each button
positions +DECAY -DECAY IB
Applying Grounding Red: charging During the time of measurement
State HV to the the sensor Green: complete Positive decay N e g a t i v e I o n
sensor plate plate time decay time balance
-page34-