ManagerIQEasy_QM_9752103070_NL_D_GB_F_V1_0 13
5. Starting up the IQ Easy system
- Switch on the Manager (and the Extension) using the on/off switch at the power input.
- Wait until the hourglass symbol on the display of the Manager disappears.
- The system is now started up.
6. Explanation of the display
Settings
Inactive or no
communication
Nothing
connected
Information
Active and
operating OK
Neutralizing
equipment
Active
Standby
Charging
equipment
Standby
Active with a
warning
Sensor
Inactive or
incorrect entry
Active with an
alarm
Detection
equipment
7. Setting up the IQ Easy system
Once a device is connected, recognized and the manager has gathered all information, most
devices will become active or inactive, depending on the start-up parameter Autorun. By default,
neutralising equipment will be activated automatically, charging equipment will go into the
standby mode. See the manual of the device, whether this Autorun parameter is present.
A connected Sensor Bar can be coupled to a neutralising bar (e.g. a Performax IQ Easy) to
operate in the Closed-Loop Feedback mode. By default, on a Sensor Bar all sensor segments
will be active.
The set point of the charging equipment must be manually set after its connection. Then the
charging equipment must also be switched on manually.
To Next Page
Loading...
Need help?
General
