11
ENGLISH
USE
PRELIMINARY CHECKS
Before starting the engine each time:
Make sure that the sea-water inlet valve is open. Operation of the
sea water pump without water would cause irreparable damage to
the internal rotor within a very few seconds.
Check the level of technical fluids (fuel, engine oil and coolant).
STARTING AND STOPPING THE ENGINE
For vessels equipped with instrument panels that
are not manufactured by IVECO MOTORS
The start-up and shut-down operations described below apply to an on-
board control panel manufactured by IVECO MOTORS; if the vessel is
fitted with an instrument panel that has been customised by the
Boatbuilder or Fitter, these operations may vary according to the various
choices made during construction. In these cases, follow the start-up/
shut-down sequence and use the instrument panel description provided
by the Boatbuilder on specific documentation.
CAUTION!
Before starting the engine, make sure that no
combustible vapours or gasses are present in the
engineroom.
To Next Page
Loading...
Need help?
General
