14
Stopping the engine
Before stopping the engine it is recommended you run it for a few
minutes at minimum speed with no load; this will allow the temperature
to drop evenly and will avoid harmful thermal shocks.
A. The engine is normally stopped from the main IVECO MOTORS
control panel by turning the key switch to the rest position 8A or
by turning a similar command on the customised control panel.
B. The IVECO MOTORS secondary control panel is stopped by
pressing the red button (6) on the control panel.
The main IVECO MOTORS control panel for engines equipped with an
“excited” device (on request or as prescribed by the Certification
Body), is stopped by pressing the red button (9).
To re-start the engine from the main control panel:
1. Return the key switch to the rest position 8A to reset all the on-
board control panel functions.
2. Proceed as indicated.
To re-start the engine from the secondary control panel:
1. Make sure that the panel has been enabled (key switch on the main
control panel turned to position 8B).
2. Press the green button (5) and release it when the engine has
started, making sure that the rev indicator is showing a plausible
reading.
To Next Page
Loading...
Need help?
General
