13
ENGLISH
Procedure for start-up from IVECO MOTORS
secondary or fly-bridge control panel (supplied on
demand)
1. Enable the secondary control panel, by turning the key
switch on the main panel to position 8B (see warnings and
procedure given in previous paragraph).
2. Wait for the beeper to stop sounding and for the alarm indicators
on the indicator module (3) to switch off, with the exception of the
“alternator recharge” and “low oil pressure” indicators. At the same
time, check that the indicator test has been performed successfully
(information on how to interpret this test and indications on the
module are given in the relevant paragraph).
3. Press the green button (5) and release it when the engine has
started.
4. Check that the rev indicator shows a plausible value.
1. Rev counter and hour counter - 2. Beeper - 3. Indicator and alarm
module - 4. Button to disable the beeper - 5. Engine start button -
6. Engine stop button.
5
1 3
2
6
4
04_355_N
To Next Page
Loading...
Need help?
General
