Need help?Do you have a question about the Ivoclar Vivadent Programat P510 G2 and is the answer not in the manual?
General| Category | Dental equipment |
|---|---|
| Control | Touchscreen |
| Double range temperature calibration (DRTC) | Yes |
| Thermal Shock Protection (TSP) | Yes |
| Power Saving Technology | Yes |
| Type | Furnace |
| Program memory | Up to 100 programs |
| Power supply | 230 V / 50-60 Hz |
Introduction to the Programat P510 G2 furnace.
Explains symbols used in the manual for clarity and safety.
Information about available voltage versions of the furnace.
Specifies the intended use of the Programat P510 G2 furnace.
Essential safety guidelines for operating the furnace and preventing hazards.
Overview of the Programat P510 G2 furnace and its capabilities.
Identifies hazardous areas and corresponding safety equipment for the furnace.
Steps for unpacking the furnace and verifying all components are present.
Guidelines for choosing a suitable and safe location for the furnace.
Step-by-step instructions for assembling the furnace components.
Steps for powering on and performing the initial setup of the furnace.
Overview of the furnace's control unit, user interface, and basic functions.
Overview of program types and customization options available for firing cycles.
How to view, edit, and adjust parameters within a selected firing program.
Exploring advanced features and procedures for updating furnace software.
Accessing and modifying various furnace settings like display brightness.
Steps for installing software updates using a USB stick.
Accessing diagnostic tools for tests, error logs, and service information.
Step-by-step guide for connecting the furnace to a wireless network.
Function to determine tooth shade using image analysis and reference teeth.
Step-by-step guide for performing a firing cycle using a pre-set Ivoclar Vivadent program.
Guide to creating and running custom firing programs with specific parameters.
Key considerations for optimal use and accurate measurements with the infrared camera.
Routine checks and maintenance tasks recommended for the furnace.
Instructions for cleaning various parts of the furnace using appropriate materials.
How to activate and utilize the power-saving mode to reduce energy consumption.
Lists and explains common error messages and their potential causes and solutions.
Describes potential malfunctions that may occur without specific error messages.
Procedure for resetting all furnace settings and programs to their original factory state.
Lists all components included in the furnace package.
Provides detailed technical specifications of the furnace, including electrical and physical data.
Specifies the environmental conditions for optimal furnace operation.
Information on obtaining and using the program table for the furnace.
To Next Page