18
FOR THE USER
Room temperature
10° 20,0 30°
Return Adjust
Set the desired room temperature
If you have a room sensor connected to the heat pump you can set the
required temperature in the room from the Room temperature menu. From
Extra functions (Customer level 2) you can also set how much you want
the sensor to infl uence the heating system.
This is what to do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Room temperature.
3. Press the Adjust button.
4. Turn the menu dial clockwise to increase the room temperature.
Turn the menu dial anti-clockwise to lower the room temperature.
5. Save the new value by pressing the Save button.
Note
The example describes how to set the
required room temperature with the
help of a connected room sensor. The
range is 10ºC to 30ºC.
Set the heat pump for extra hot water
You can obtain extra hot water by temporarily increasing the temperature
of the water in the hot water cylinder. This may be appropriate when, for
example, a large number of people need to shower. You choose how long
the function should run using the Extra DHW menu. This is what to do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Extra DHW.
3. Press the Adjust button.
4. Turn the menu dial clockwise to choose the number of hours that the
electric cassette should be on (e.g. 24 hours).
5. Save the value by pressing the Save button.
When the set time has elapsed you
must repeat the setting to get extra
hot water again.
Note
Basic functions - Customer level 1
Extra DHW
1h 24h 48h
Return Adjust
Extra DHW
1h 24h 48h
Return Save
To Next Page
Loading...
Need help?
General
