Ivy Biomedical Systems 3000 Series Service Manual

MONITOR DESCRIPTION
Controls and Indicators
Basic Keys
When the monitor is plugged into an AC power source the ON switch, when pressed, provides power to
the monitor’s electronic circuits.
The STBY switch, when pressed, disconnects power from the monitor’s electronic circuits.
NOTE: To disconnect the monitor from the main power unplug the AC power cord.
Disables the audible and visual alarms for a two-minute period to allow the operator to perform
procedures that would otherwise set off the alarms. This avoids the problem of turning off the alarms and
forgetting to turn them back on. Press this key again to return the alarms to normal before the two minutes
have expired. Pressing ALARM PAUSE key for 3 seconds will turn alarms off. Press ALARMS PAUSE
key again to reactivate the alarms. Pressing ALARM PAUSE key will pause the alarms for 120 seconds
(2 minutes).
This key enables or disables (arm or disarm) the ECG storage function of the monitor allowing the user to
save up to 60 seconds of ECG signal in a 3.5 inches floppy disc.
When the ECG data has been successfully stored this key opens a special menu to re-write data, clear
memory or patient ID.
Use as a backspace when entering the patient ID.
Recorder
Alarm Pause
Key
Stand By switch
(Basic Key)
ON switch
(Basic Key)
Programmable
Keys
Keypad
(Only available in Model s
3100 and 3150)
ECG Patient
Cable Connector
Model 3000 Series Service Addendum
10

Ivy Biomedical Systems 3000 Series Specifications

General

Brand	Ivy Biomedical Systems
Model	3000 Series
Category	Monitor
Language	English