SINGLE LINE TELEPHONE
STATION USER
QUICK REFERENCE GUIDE
Using the Receiver Button to Access ADIX
Features - By performing a hookswitch flash
(quickly pressing and releasing the Receiver
Button) and dialing the desired Feature
Operation Code, you can easily access ADIX
features.
Each feature operation code must be
programmed in the ADIX database by your
system installer. Space is provided on the inside
back cover of this guide to write your feature
operation codes for quick reference. Check with
your telephone system administrator if you
encounter problems accessing any of the
features described in this guide.
BASIC FEATURES
Making An Outgoing Call
þ
Lift the receiver
þ
Dial the outside line access code*
þ
When you hear the dial tone dial the
telephone number
Make a Dialing Mistake?
þ
Hang up, then start again
Receiving An Incoming Call
When your phone rings:
þ
Just lift the receiver. The call is automatically
connected
* All access codes are programmed by the system
911 Support
At default, ADIX is programmed to automatically
contact your local Public Safety Answering Point
(PSAP) when 911 is dialed. In addition, ADIX is
one of the only systems that supports Enhanced
911 Service. Enhanced 911 Service ensures that
when 911 is dialed from a system extension,
information that allows the PSAP to identify the
caller’s location in a building is sent to the PSAP
along with the call. Check with your system
installer or Authorized Iwatsu Distributor to
make sure your system is programmed for
Enhanced 911 Service.
INTRODUCTION
To Next Page
Need help?
General
