Need help?Do you have a question about the J. D. NEUHAUS PROFI 10 Ti and is the answer not in the manual?
Requirements for personnel operating, maintaining, or inspecting hoists.
Information on ATEX compliance and use in explosion-hazardous areas.
Table for selecting hoists based on explosion group, zone, and operation type.
Permissible uses and classification of non-intended uses for the hoists.
Suitable environments and operating parameters like pressure and air quality.
Critical safety and installation procedures for hoists.
Detailed instructions for connecting various control systems.
Proper connection of the air supply for hoist operation.
Essential pre-operation checks by qualified personnel.
Operator responsibilities and general safety guidelines.
Overview of different control systems and their operation.
Functionality and safe use of the emergency stop.
Safe methods for attaching loads to the hoist.
Step-by-step guide and safety for lifting operations.
Step-by-step guide and safety for lowering operations.
Daily and load-based checks of the brake system.
Testing the hoist's upper and lower limit stops.
Ensuring the emergency stop button functions correctly.
Understanding and adjusting the hoist's overload protection mechanism.
Method for adjusting the overload protection limit value.
Procedure for correcting the overload protection limit setting.
Procedure for resetting the overload protection limit value.
Comprehensive table of faults, causes, and recommended remedies.
General| Type | PROFI 10 Ti |
|---|---|
| Air pressure | 6 bar |
| Drive | Pneumatic |
| Control | Pendant control |
| Number of Falls | 2 |
| Operating Temperature | -20°C to +70°C |
| Protection Class | IP 65 |
| Chain Size | 10 mm |
| Load Capacity | 10, 000 kg |
| Material | High-strength steel |
To Next Page
