Need help?Do you have a question about the J. D. NEUHAUS PROFI 6 Ti and is the answer not in the manual?
Requirements for trained personnel operating, maintaining, and inspecting JDN Air Hoists.
Information on JDN Hoists in explosion-hazardous areas based on ATEX guidelines.
Details suitable operating environments, temperatures, and air supply requirements.
Explanation of how system pressure affects hoist operation and load lifting.
Critical safety warnings and requirements for installing the hoist.
Operator responsibilities for safety and adherence to procedures.
Essential safety points to be observed when using JDN Air Hoists.
Description of the hoist's direct-acting overload protection safety clutch.
Dangers and precautions when attaching loads to the hoist hook.
Warning and procedure for dismantling the hoist by qualified personnel.
Importance of intervals and reducing them in wear-promoting conditions.
Details on classification, theoretical operating time, and general overhaul.
Procedure for testing lifting and lowering limiters and buffers.
Procedure for testing the emergency stop button function.
Criteria for replacing the hoist chain and checking sprockets/guides.
Method for adjusting overload protection based on test loads.
Procedure for correcting the limit value setting of the overload protection.
Procedure for resetting the limit value of the overload protection.
Table of technical specifications for different JDN Air Hoist models.
General| Type | PROFI 6 Ti |
|---|---|
| Category | Chain Hoists |
| Operation | Pneumatic |
| Air Pressure | 6 bar |
| Temperature Range | -20°C to +70°C |
| Lift Height | 3 m |
| Chain Length | Available upon request |
| Load Capacity | 6 t |
To Next Page
