How to fix Jablotron Security System when impossible to enroll a wireless item?
If you find it impossible to enroll a wireless item in your Jablotron Security System, it might be due to an unsuitable location where the radio signal level is too low. This could be because the item is too far away or there's an obstacle blocking communication. Try changing the item's location. Temporarily secure it in the new spot first to test if it works.
Why my Jablotron Security System does not communicate with connected PC?
If your Jablotron Security System does not communicate with the connected PC, the PC-60A cable might not be connected to the correct COM connector on the PC. Check the connection or manually select the port number in the software.
What to do if connected JA-60E keypad of Jablotron Security System has no function?
If the connected JA-60E keypad of your Jablotron Security System has no function, it might be due to the connecting cable not properly linking the corresponding positions in the keypad and control panel (1-1, 2-2, 3-3, 4-4). Check the colors of the cores in the cable and the positions on each side to ensure they match.
What to do if Jablotron Security System keypad indicates a fault and is beeping?
If your Jablotron Security System shows a fault indicated on the keypad and it is beeping, check the reason of the trouble in the user manual and fix it, or call the installer.
Power| power | 230 VAC |
|---|---|
| max current | 0.1 A |
| backup battery voltage | 12 V |
| backup battery capacity | 1.3 or 2.6 Ah |
| backup power output voltage | 13 VDC |
| max permanent current | 0.4 or 1 A |
| self-consumption of the control panel | 30 mA |
Operating Environment| environmental class | II indoor – general (-10 to 40 °C) |
|---|---|
| compliance | EN 50131-1, EN 50131-6 security grade 2 |
| safety | EN 60950, class II |
To Next Page
