JABRA GN9120
JABRA
®
IS A REGISTERED TRADEMARK OF GN NETCOM A/S
WWW.JABRA.COM
VERIFY THAT YOU HAVE RECEIVED A CORRECT REPLACEMENT BATTERY
INSTRUCTIONS
How to replace battery in Jabra Gn9120
usinG tHe battery replacement kit
THIS IS WHAT YOU DO:
- Lift the headset from the base and take off the ear-cushion (1)
- Separate the boom-arm and speaker part from wearing style
(headband/ear hook) (2)
- The battery becomes visible
- The battery is either locked by a screw (A) or by a plastic clip (B)
A. IF THE BATTERY IS LOCKED BY A SCREW
- Use the screwdriver in the replacement kit to unscrew the lock
(3-4)
- Slide the battery out of the headset (5)
- Insert the battery from the replacement kit into the headset (6)
- Use the screwdriver in the replacement kit to screw lock back on
(7-8)
- Put boom-arm and speaker part back together
- Put ear-cushion back on the headset
- Charge the headset for 2 hours until the base station battery
indicator goes solid green
If this does not happen within 2 hours, make sure that the battery
is inserted correctly as shown on next page – or visit Jabra.com
- When fully charged the headset is ready to use
Batteries “Made by ATL” must be replaced by a Synergy battery
with sticker.
The replacement battery carries a “Made by Synergy” mark and
sticker. THIS BATTERY IS SAFE TO USE.
1
(3-4) Only one screw
needs to be unscrewed.
To Next Page
Need help?
General
