Jabra GN9120 Flex NC Microphone With EHS
How to connect my Jabra GN9120 EHS / GN9125 EHS with
Nortel IP 1120E, 1140E, 1150E, 1165E
Prerequisite:
Jabra GN9120 EHS + Jabra Link 14201-32 (from FW 2.2.0)
Jabra GN9125 EHS + Jabra Link 14201-32 (from FW 2.2.0)
In combination with one of the following phones:
Nortel IP 1120E
Nortel IP 1140E
Nortel IP 1150E
There is a minimum revision level (UNIStim 5.2) needed when using our
EHS adapter on Nortel 1140e with CS2100 server. The CS1000 is OK
with 3.1 or greater. It can be downloaded from
http://support.nortel.com.
Connection:
1. Connect the 1-sided end (USB plug) of the EHS adapter with the USB
socket on your phone phone.
2. Insert the RJ10 plug into the socket identified with the “phone”
symbol and the RJ45 plug into the socket identified with "AUX" on
the base.
EHS setup:
The Jabra GN912x must support and be set up on DHSG EHS.
Proceed as follows to check the EHS installed:
To Next Page
Need help?
General
