37 / 51
state, the engaging distance between the point of moving blade and fixed
blade is 0.5-1 mm (figure 7), adjustments can be loosen screw 1 (figure 9),
moving the fixed blade to adjust the relative position of the moving blade
with the fixed blade, engaging distance between the moving blade and the
fixed blade is 0.5-1 mm , at that time the moving blade is parallel to the fixed
blade (figure 7 and figure 8).
Loosen the screw 1 to adjust the before and back distance , and ensure
that the clip is parallel to the fixed blade. (FIG. 10).
The adjustment of the clip can be adjusted by adjusting the screw 4,
moving the clip, to make the distance between it and fixed cutter is 4mm,
and is parallel to the set cutter. (figure 11).
图 7
To Next Page
Loading...
