4
/
8
3.3 Speed adjustment
Press
or to change the speed. 50 difference once a time and can press constantly.
3.4 Factory setting
Press for factory setting.
3.5 Method to monitors mode
Press and shows monitors number,press or to change the monitors number,press
to enters into the related value of monitors number, press again to return the monitors reference
number.(if the monitor number is 24、25、26、28, press shortly when shows the related value then can
back to the monitors number,press to save the current monitors’ value and if shows ok, it means saved
successfully. Press shortly and exit the monitors mode.)
Note: how to set needle position, enters parameter 24 and adjust hand wheel to change the needle position, then
press to check the value, then press for a long time (needle position will change accordingly), press to
exit monitors mode.
3.6 Parameters
3.6.1 Operators parameter
param
descriptions
Factory
range
num
descriptions
Factory
range
P00 Starting speed (r/min) 200
100-80
0
P23
Curve mode of the pedal
0
:
straight line
1
:
two phase slope
2
:
curve
(
square
)
:
0 0-3
P01 Highest speed (r/min) 3500
200-50
P24
Thread trimmer position of the
150 0-4095
P02
Multi-phase speed
3000
200-35
P25 Back safty stitch(sucking) 27 1-120
P03
Needle position
:
:
1 0-1 P26 Front safty stitch(releasing) 18 1-120
P04
Front bar tack sewing
1800
200-30
P29
Auxiliary parameters
:
1 0-1
P05
Back bar tack sewing
speed(r/min)
1800
200-30
00
P30
Powerful when the motor
under low speed 0
:
normal
—
0 0-31
P06 W sewing speed(r/min) 1800
200-30
P31 Thread trimmer strength 40 10-60
P07
Slow starting sewing
speed(r/min)
800
100-80
0
P32
Tread tension magnet
time(from beginning to full
40 1-200
企业识别系统手册
CORPORATE IDENTITY SYSTEM
GUIDELINES