Jackson Labs LC_XO - Other Options; Sending Manual Commands to the Receiver

© 2012 Jackson Labs Technologies, Inc. 21
LC_XO GPSDO User Manual
Figure 3.9 Auxiliary Parameters window
3.3.1.4 Other options
The other tabs in the options window can be selected and you can set whatever options you need,
such as paths for logging or exporting graphics.
3.3.2 Sending manual commands to the receiver
You can send SCPI commands manually by using the drop-down box under the display window as
shown in Figure 3.10. Care must be taken when sending these commands so be sure that the
command that you select is supported by the LC_XO GPSDO board. Once you’ve selected the
command, you can press “Send” to send it to the LC_XO board.