Jackson Labs LC_XO - Measure; SYSTEM Subsystem; System:communicate; System:communicate:serial:echo

To Next Page

To Previous Page

LC_XO GPSDO User Manual

4.7.3 MEASure?

This command is not supported on LC_XO, and will return undetermined values.

4.8 SYSTEM Subsystem

This subsystem regroups the commands related to the general configuration of the LC_XO. The list

of the commands supported for this subsystem follows:

SYSTem:COMMunicate:SERial:ECHO <ON | OFF>

SYSTem:COMMunicate:SERial:PROmpt <ON | OFF>

SYSTem:COMMunicate:SERial:BAUD <9600 | 19200 | 38400 | 57600 | 115200>

SYSTem:STATus?

SYSTem:FACToryReset ONCE

4.8.1 SYSTem:COMMunicate

4.8.1.1 SYSTem:COMMunicate:SERial:ECHO

This command enables/disables echo on RS-232. This command has the following format:

SYSTem:COMMunicate:SERial:ECHO <ON | OFF>

4.8.1.2 SYSTem:COMMunicate:SERial:PROmpt

This command enables/disables the prompt “scpi>” on the SCPI command lines. The prompt must be

enabled when used with the software GPSCon. This command has the following format:

SYSTem:COMMunicate: SERial:PROmpt <ON | OFF>

4.8.1.3 SYSTem:COMMunicate:SERial:BAUD

This command sets the RS-232 serial speed. The serial configuration is always 8 bit, 1 stop bit, no

parity, no HW flow control. Upon Factory reset, the speed is set at 115200 bauds. This command has

the following format:

SYSTem:COMMunicate:SERial:BAUD <9600 | 19200 | 38400 | 57600 | 115200>

4.8.2 SYSTem:STATus?

This query returns a full page of GPS status in ASCII format. The output is compatible with

GPSCon.

4.8.3 SYSTem:FACToryReset ONCE

This command applies the Factory Reset setting to the EEPROM. All aging, tempco, and user

parameters are overwritten with factory default values.