LC_XO GPSDO User Manual
40 © 2012 Jackson Labs Technologies, Inc.
Please see the SYNChronization? command for detailed information on how to decode the health
status indicator values.
Note: health status information is available with firmware versions 0.913 and later.
The Lock State variable indicates one of the following states:
4.9.11 SERVo?
This command returns the result of the following queries:
SERVo:COARSeDac?
SERVo:DACGain?
SERVo: EFCScale?
SERVo:EFCDamping?
SERVo:SLOPe?
SERVo:TEMPCOmpensation?
SERVo:AGINGcompensation?
SERVo:PHASECOrrection?
SERVo:1PPSoffset?
SERVo:TRACe?
Valu e St ate
0 OCXO warmup
1 Holdover
2 Locking (OCXO training)
4 [Value not defined]
5 Holdover, but still phase locked (stays in this state for about 100s after GPS lock
is lost)
6 Locked, and GPS active
To Next Page
Loading...