What to do if the Jackson Avenger HT doesn’t drain when the “OFF/DRAIN” switch is pressed?
If your dishwasher isn't draining, start by removing any obstructions that might be blocking the drain. If that doesn't work, consider replacing the part.
How to fix water overflow from the bottom of the Jackson Dishwasher door?
If you're experiencing water overflow, try these solutions: First, remove any obstructions that may be causing the overflow. Next, ensure the machine is level, and if not, increase the height to the front. If the issue persists, install a pressure reducing valve, or adjust the existing one to ensure the flow is 20 ±5 PSI. Finally, try reducing the amount of detergent you're using.
What to do if the wash temperature is not at the required reading on the Jackson Avenger HT?
If the wash temperature isn't reaching the required level, try the following: First, ensure the water is turned on. You can also try to adjust or replace the thermostat, or replace the heater element and pressure gauge. Note that there is additional information on page 12. Finally, consider replacing the part.
Why is there little or no water coming through the rinse assemblies of my Jackson Avenger HT Dishwasher?
If you're experiencing low water flow through the rinse assemblies, try deliming the rinse heads. Additionally, you might need to increase the pipe size to the machine and adjust the pressure regulator.
What to do if the Jackson Avenger HT rinse water is not at the required temperature range?
If the rinse water temperature is not within the required range, see the note in the installation instructions. You can also try adjusting the thermostat, replacing it if necessary, or making other necessary adjustments.
Why does the Jackson Avenger HT Dishwasher rinse water run continuously even with the breaker turned off?
If the rinse water continues to run even after the breaker is turned off, consider replacing the part or the diaphragm.
What to do if no water comes through the rinse arms when the “ON/FILL” switch is depressed on Jackson Dishwasher?
If no water is coming through the rinse arms, first ensure that the water is turned on. If the problem persists, consider replacing the solenoid valve.
What to do if the wash motor doesn’t operate on manual wash in Jackson Avenger HT?
If the wash motor isn’t working on manual wash, try reconnecting or replacing the wires in the motor. If that doesn't solve the problem, consider replacing the motor.
What to do if the motor operates on manual wash but not on automatic in Jackson Avenger HT Dishwasher?
If the motor works in manual mode but not automatically, replace the switch.
What to do if there is no indication of pressure in Jackson Avenger HT?
If there is no pressure indication, first ensure that the water is turned on. If the issue persists, replace the pressure gauge.
Details the scope and duration of the limited warranty for parts and labor.
Specifies geographical and time limits for warranty service travel.
Instructions for returning the warranty card to validate coverage.
Outlines the warranty period for Jackson replacement parts.
Manufacturer reserves the right to make design and specification changes.
Lists exclusions from the manufacturer's warranty coverage.
Lists performance, electrical, and water requirements for Avenger™ HT.
Lists performance, electrical, and water requirements for Avenger™ LT.
Provides dimensional drawings and key connection points for the Avenger™ HT.
Provides dimensional drawings and key connection points for the Avenger™ LT.
Covers visual inspection, unpacking, leveling, and plumbing connections.
Details procedures for safe and correct electrical power connection.
Explains setup and priming of chemical feeder pumps for operation.
Guides technicians on programming chemical feeder pump timing and outputs.
Discusses factors affecting detergent use and efficiency, including water hardness.
Covers preparation, filling, ware preparation, and daily machine operation.
Provides steps for removing lime and corrosion deposits from the dishmachine.
Outlines operator responsibilities and recommended maintenance practices for optimal performance.
Lists common issues and their potential causes and solutions for dishmachine operation.
Details components and assembly of control panels for HT and LT models.
Lists parts for the Avenger™ HT 480V control panel assembly.
Shows parts for the HT model's control panel and kick panel weldment.
Shows parts for the LT model's control panel and kick panel weldment.
Illustrates the components of the terminal block box assembly.
Details parts for the Avenger™ HT chemical feeder pump assembly.
Details parts for the Avenger™ LT chemical feeder pump assembly.
Shows individual components of the chemical feeder pumps.
Lists parts for the incoming and vacuum plumbing assemblies for Avenger™ HT.
Lists parts for the incoming and vacuum plumbing assemblies for Avenger™ LT.
Shows parts for solenoid valves, vacuum breakers, and water hammer arrestors.
Details parts for the wash motor, drain plumbing, and LT wash manifold.
Lists components for the motor and pump assembly.
Shows parts for the rinse and wash arm assemblies.
Details parts for the HT model's thermostat and rinse tank.
Shows parts for the LT model's thermostat and heater components.
Lists components for the dishmachine door assembly.
Details smaller parts related to the dishmachine door.
Shows parts for the dishmachine frame, shrouds, and panels.
Lists various other parts such as racks, shields, and strainers.
Details parts for the 6" and 18" stand assemblies.
Shows the HTS-11 system, cartridge, and test strip.
Lists components included in the Go*Box repair kit.
Details parts for the vacuum switch assembly.
Provides instructions for installing the vacuum switch assembly.
Presents the electrical schematic for the HT model at 208-230V.
Presents the electrical schematic for the HT model at 480V.
Presents the electrical schematic for the LT model at 115V.
Lists Jackson service centers in Alabama, Florida, Georgia, and other southern states.
Lists service centers in Florida, Georgia, Hawaii, Idaho, Illinois, Indiana, Iowa, Kansas, Kentucky, Louisiana, Maine, Maryland.
Lists service centers in Maryland, Massachusetts, Michigan, Minnesota, Mississippi, Missouri, Montana, Nebraska, Nevada, New Hampshire, New Jersey.
Lists service centers in New York, North Carolina, North Dakota, Ohio, Oklahoma, Oregon, Pennsylvania.
Lists service centers in Pennsylvania, Rhode Island, South Carolina, South Dakota, Tennessee, Texas, Utah, Vermont, Virginia.
Lists service centers in Wisconsin, Wyoming, and international locations.
General| Brand | Jackson |
|---|---|
| Model | Avenger HT |
| Category | Dishwasher |
| Language | English |
To Next Page