CONTROLS 4
en-25
4.2.6.14 THROTTLE MODE _______________________________________________________
Navigate to the Vehicle Settings Menu.
Use the UP and DOWN arrow keys until the green arrow is
next to Mode. Press the select button to select Mode.
There are three modes, Automatic (A), Manual (M) and Garage. The mode
selection can only be changed when the machine is stopped.
Automatic Mode (A) - Automatic throttle and drive features enabled.
• Climb assist - Load sensing system adjusts engine throttle and
ground speed for efficient slope climbing
• Cut assist - Load sensing system adjusts engine throttle and ground
speed to maintain optimum cutting performance
• Auto Idle - Throttle drops to idle when pedal returns to neutral during
transport operations,
Garage Mode - The cutting system is disabled, engine operates at 20%
throttle and max speed limited to 5 mph (8km/h) for safe, controlled use in
workshops, storage facilities and when loading onto vehicles
Manual Mode (M) - The engine speed is set at a fixed value that can be
changed using the Manual Throttle menu.
4.2.6.15 MEASURE UNITS________________________________________________________
Navigate to the Vehicle Settings Menu.
Use the UP and DOWN arrow keys until the green arrow is
next to Measure Units. Press the select button to select Measure Units.
Use the arrow keys to change the unit of measure. The speed unit of measure
can be set to either Mph or Km/h. The temperature unit of measure can be set
to either °F (Fahrenheit) or °C (Celsius).
Automatic
Garage
Manual
Mode Setting
Mode
Measurement Settings
Pin
Vehicle Settings Menu
Speed MPH
Temperature °F
Measurement Units Settings
Mode
Measurement Settings
Pin
Vehicle Settings Menu
To Next Page
Loading...
Need help?
General
