CONTROLS 4
en-43
4.2.6.49 WARNING DISPLAY CAN TIMEOUT_________________________________________
This screen is shown if there is no CAN communication is detected by the
display for 3 seconds.The LED will flash and the horn will sound two times
every five seconds
Stop the machine as soon as possible and contact your service dealer. Check
the armrest and controller harness connections.
4.2.6.50 WARNING BATTERY FAULT _______________________________________________
When this screen is shown, the battery is below 10.5V for 30 seconds. The
LED will flash and the horn will sound two times every five seconds.
4.2.6.51 WARNING SERVICE NEEDED _____________________________________________
When this screen is shown, scheduled maintenance is required.
4.2.6.52 EMISSION FAULT - MAF SENSOR __________________________________________
When this screen is shown, the engine controller (ECU) is reporting a fault
with the MAF (Mass Air Flow) s
ensor. The output from the engine will be
reduced. Stop the engine as soon as possible and contact your l
ocal
Jacobsen Dealer.
12:00:00
0.0 Hours
TST
™
!
Display CAN Timeout Fault
1/1
TST
™
9:25 AM 07/08/2017
12345.6 Hours
!
Low Battery Fault
1/1
TST
™
9:25 AM 07/08/2017
12345.6 Hours
!
205 machine hours.
Please refer to manual
for routine matinance
1/1
TST
™
9:25 AM 07/08/2017
12345.6 Hours
!
205 machine hours.
Please refer to manual
for routine matinance
1/1
MAF Sensor Fault
!
5/5
To Next Page
Loading...
Need help?
General
