4 CONTROLS
en-42
4.2.6.45 WARNING HYDRAULIC OIL LEVEL_________________________________________
This screen is shown if the hydraulic oil level is low. The LED will flash and
horn will sound six times every six seconds.
Stop the machine immediately and check for oil leaks.
The Mow solenoid and joystick lower function is disabled until warning is
cleared.
4.2.6.46 WARNING BRAKE/TRACTION PEDAL ______________________________________
This screen is shown if the traction pedal is pressed with the parking brake
switch in the ON position. The LED will flash four times every two seconds
and the horn will sound constantly until the traction pedal is returned to the
Neutral position or the parking brake switch is moved to the OFF position.
Remove your foot from the traction pedal and disengage the parking brake
before you drive the mower.
4.2.6.47 WARNING ECU CAN TIMEOUT ____________________________________________
This screen is shown if there is no CAN communication from the ECU for 3
seconds. The LED will flash and the horn will sound two times every five
seconds.
Stop the machine as soon as possible and contact your service dealer. Check
the controller harness connections.
4.2.6.48 WARNING MCU CAN TIMEOUT ____________________________________________
This screen is shown if there is no CAN communication from the MCU for 3
seconds. The LED will flash and the horn will sound two times every five
seconds.
Stop the machine as soon as possible and contact your service dealer. Check
the controller harness connections.
12:00:00
0.0 Hours
TST
™
!
Hydraulic Oil Level Fault
1/1
12:00:00
0.0 Hours
TST
™
!
Release Brake Fault
1/1
12:00:00
0.0 Hours
TST
™
!
ECU CAN Timeout Fault
1/1
12:00:00
0.0 Hours
TST
™
!
ECU CAN Timeout Fault
1/1
12:00:00
0.0 Hours
TST
™
!
MCU CAN Timeout Fault
1/1
To Next Page
Loading...
Need help?
General
