CONTROLS 4
en-41
4.2.6.41 WARNING OIL-PRESSURE FAULT__________________________________________
When this screen is shown, the engine oil pressure has decreased below the
normal level. The LED will flash and the horn will sound every four seconds.
If this happens during operation, Stop the engine and check the oil level. Top
up if necessary. If the problem persists consult your service dealer.
4.2.6.42 WARNING ENGINE OVERHEAT ____________________________________________
When this screen is shown, the engine temperature has risen above the
normal levels. The LED will flash and the horn will sound two times every two
seconds.
Park the machine in a safe area disengage cutting implements, set engine to
idle to allow engine temperature to decrease prior to switching off the engine.
Clean the radiator and screens of all grass and debris.
The Mow solenoid and joystick lower function is disabled until warning is
cleared.
4.2.6.43 WARNING HYDRAULIC OIL FILTER ________________________________________
This screen is shown when the hydraulic oil filter needs to be replaced. The
LED will flash and horn will sound five times every five seconds.
Return the machine to the service area and replace the filter.
The Mow solenoid and joystick lower function is disabled until warning is
cleared.
4.2.6.44 CLEAN DPF ASH _______________________________________________________
When this screen is shown, the engine controller (ECU) is reporting that the
level of ash in the DPF (Diesel Particulate Filter) is in excess of 95% and
therefore requires servicing. Contact your local Jacobsen dealer for
information on the procedure for servicing the DPF.
12:00:00
0.0 Hours
TST
™
!
Engine Oil Pressure Fault
1/1
12:00:00 1/1/2016
0.0 Hours
TST
™
!
Engine Overheat Fault
1/1
12:00:00
0.0 Hours
TST
™
!
Hydraulic Oil Filter Fault
1/1
12:00:00
0.0 Hours
TST
™
!
1/1
Clean DPF Ash
!
1/1
To Next Page
Loading...
Need help?
General
