12 QUALITY OF CUT
75
12Quality o f Cut
12.1 QUALITY OF CUT PROBLEM SOLVING _______________________________________
Make a “test cut” to check the performance of the mower before you start the repairs.
This area must have turf conditions that are known and do not change across the area. This type of area allows an
accurate inspection of the perfomance of the mower to be made.
Another “test cut” must be done after the repairs or adjustments to confirm the mower’s performance.
Before you do a “test cut” to show the appearance and performance of the mower, the following items must be
confirmed. These items make sure that the “test cut” is accurate.
1. Cut (Ground) Speed
2. Blade Sharpness
3. Height-of-Cut (HOC)
4. Caster Wheel Bearing Condition
5. Blade Speed
12.2 WASHBOARDING _________________________________________________________
NOTE: Arrow indicates direction of travel.
Washboarding is a repeated pattern of different cutting
heights, that causes an appearance that is like a wave. In
most cases, the wave tip-to-tip distance is approximately
6—8 in. (15—20 cm). A change in the color (from light-to-
dark) is also seen.
This cause of this condition can be a movement from side
-to-side in the cutting units (s). This condition is found on
mowers with cutting units held under the mower, but other
cause can give the same result.
Another cause of Washboarding is differences in the type
of turf.
Probable Cause Remedy
Cutting units have too much or too little weight on
them.
Adjust the weight transfer valve to increase weight on the
cutting units. See 10.9.
To Next Page
Loading...
Need help?
General
