4 CONTROLS
en-17
4.2.5 LIFT/LOWER JOYSTICK ____________________________________________________
The lift/lower joystick controls the cutting units lift and lower. The lift/lower joystick operates
in One-Touch or manual mode. Push the lift/lower joystick to lower the cutting units or pull
the lift/lower joystick to lift the cutting units.
The One-Touch or manual mode is set on the display.
Manual Mode - When One-Touch is disabled, the cutting units will lift or lower only while
the lift/lower joystick is pulled or pushed.
One-Touch Mode - With One-Touch enabled and the mow switch is in the ON position,
push and release the lift/lower joystick to lower the cutting units to the ground and start the
reel. Pull and release the lift/lower joystick to completely lift the cutting units and stop the
reels.
4.2.6 VISUAL DISPLAY _________________________________________________________
The visual display is activated when the key switch is turned to the ‘RUN’ position.
4.2.6.1 STARTUP SCREEN_______________________________________________________
When the key switch is turned to the ‘RUN’ position, this screen is shown for
two seconds.
The hour meter will show total hours of engine operation.
0.0 Hours0.0 Hours
To Next Page
Loading...
Need help?
General
