8.0 Control Functions
8.1 Control Panel
A. LED Display: can
display current
water temperature
(default display),
water temperature
setpoint, selected
skimming/heating
mode, and error
messages.
B. Warmer ( + ) Button: increases water temperature setpoint.
C. Cooler ( - ) Button: decreases water temperature setpoint.
D. Light Button: turns underwater light on and off.
E. Jets 1 Button: turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
F. Jets 2 Button: turns high-speed jets pump #2 on and off. Press once to
turn on; press a second time to turn pump off (2-pump models only).
G. Heat Indicator: lit when heater is on.
Operation Details
•Temperature Adjustment: 65 to 104 °F (18 to 40 °C). Factory
default setting is 100 °F (38 °C).
• Underwater Light Operation: light runs for 1 hour then shuts
off for increased bulb life.
•Jets 1/Jets 2 Button Operation: jets run for 20 minutes after
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
Page 14
To Next Page
Loading...
