EasyManuals Logo

Jacuzzi AERO PLUS PortableWhirlpoolSpa User Manual

Jacuzzi AERO PLUS PortableWhirlpoolSpa
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
2. Heater not functioning.
18
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE
*Note: The skills and tools necessary for the safe repair of this spa require the services
of qualified service personnel. Contact your dealer.
A. Actuated too rapidly
3. Heater not functioning but
heater light on.
A. Heater mode not selected.
B. No power to heater.
C. Thermostat set lower
than water temperature.
D. High temperature safety
switches tripped.
E. Abnormally low water flow.
F. Heater relay not operating.
G. Heater element failure.
H. Improper 230 VAC
Conversion
A. *
B. *
A. Select Heater/Filter mode.
B. Check house circuit breaker
and GFCI.
C. Turn to desired temperature.
D. Reset buttons on heater after
water has cooled; see *Note if
switches continue to trip.
E. See Remedy 6 below.
F. *
G. *
H. Contact electrician.
A. Select JETS mode for maximum
flow.
B. Fill to water level indicator
mark on skimmer/filter frame.
C. Fill to middle of skimmer.
D. Clean strainers or skimmer baskets
E. Clean or replace.
A. Wait 60 seconds; system
will be restored automatically.
A. Relay malfunction.
B. Element malfunction.
A. Clogged or blocked suction
strainer or skimmer basket.
B. Filter clogged (dirty).
C. Poor water chemistry.
D. Insufficient filtering time.
E. mproper maintenance.
F. High content of solids in water.
A. Clean strainer/skimmer basket.
B. Clean or replace.
C. See “Chemistry” section.
D. Run filter.
E. See Maintenance section.
F. Use clarifier or drain and refill
spa.
4. Water not clean.
A. Leak in suction line, dis-
charge line, or connections.
B. Excessive evaporation and/or
splashing.
A. Repair leak.
B. Use rigid spa cover; lower
thermostat setting.
5. Abnormal water usage.
A. Normal operation in FILTER or
HTR/FILTER mode.
B. Low water level.
C. Low Water Level
D. Clogged or blocked suction
strainer or skimmer basket.
E. Dirty filter.
F. Suction or discharge line
partially plugged.
G. Pump running at subnormal speed.
H. Worn or damaged pump seal.
6. Low water flow from jets.
F. *
G. *
H. *
REMEDY

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi AERO PLUS PortableWhirlpoolSpa and is the answer not in the manual?

Jacuzzi AERO PLUS PortableWhirlpoolSpa Specifications

General IconGeneral
BrandJacuzzi
ModelAERO PLUS PortableWhirlpoolSpa
CategoryHot Tub
LanguageEnglish

Related product manuals