Alternate Use of Water Rainbow Spout as Fill Spout
You can use your Water Rainbow spout as a fill spout by permanently plumbing it to a fresh water supply if local
codes permit. Local plumbing codes may require the use of an anti-siphon valve for such a connection. Do not
interconnect water supply with recirculating system of the spa.
To make the connections necessary to use the Water Rainbow as a fill spout, follow this procedure:
Make sure spa is unplugged and completely drained.
Unscrew the spout from the 3/4" pipe.
Cut 3/4" piping as shown in illustration below.
Cap off the piping by cementing a 3/4" PVC cap where cut has been made.
Connect permanent plumbing line to the spout.
•
•
•
•
•
21
CUT PIPING HERE
(LEAVE 1 1/2"-2")
TEE ON DISCHARGE
PIPING
INSTALL AND CEMENT
3/4" PVC CAP
SAVE FOR LATER
IF DESIRED
WATER RAINBOW SPOUT
To Next Page
Loading...
