Jacuzzi Avalanche - Setting Up Your System

Setting up your system:
Step 1
Install threaded end of interconnect pipe into
the filter “INLET.” Tighten until O-ring seals
against filter.
NOTE: Be sure union nut is placed on inter-
connect pipe before it is threaded into filter.
Threads on union nut should face away from
the filter.
Step 2
Place filter on base in upright position with
interconnect pipe facing the pump position.
Press firmly down on filter, pushing it down
into base.
Step 3
Be sure that O-ring is firmly seated in O-ring
groove in the end of interconnect pipe.
4
O-Ring