NOTE: Never lift the cleaner out of the pool by the floating
cable.
Figure 6. Remove cleaner using the handle
SECTION 5. MAINTENANCE
WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death,
disconnect (unplug) the cleaner from the power
source before performing any cleaning and
maintenance.
5.1 CORD TANGLING
Tangling can occur more frequently when the cleaner
is not attended to after each cleaning cycle. Proper
installation, general maintenance and the following
troubleshooting steps can help to avoid cable
challenges.
IMPORTANT
Cleaner power cable may become tangled if correct
procedure is not followed after each cleaning cycle.
NOTE: Place all of the oating cable in the water to allow
free movement in your pool from the central point.
Spread out the oating cable ensuring there are no
kinks or coils in the cable (Figure 7).
caddy /
control unit
cleaner
cleaner
Recommended
entry point
Not
Recommended
WARNING: Do not use
an extension cord
Figure 7. Optimal Entry Point in Pool
If tangling occurs, follow these steps:
1. Remove the cleaner from the pool. When the
cleaner is within arm's reach, use the handle
to remove from the water. Never lift the
cleaner out of the pool by the fl oating
cable.
9
OWNER'S MANUAL
To Next Page
Loading...