Jacuzzi ERIKA 48 - Page 11

11
1. Drill a pilot hole for the sliding door guide (N) using a ø3mm (1/8in) drill bit.
2-3. Drill a pilot hole for the roller guide track’s anchor (P) using a ø6mm (1/4in) drill bit. Insert the wall anchors (GG)
usingarubbermalletuntilthewallanchorsareushwiththewall.
4. Install the sliding door guide (N) with the screw (CC) and the cap (II).
5-6. Install the roller guide track’s anchor (P) onto the roller guide track (O) using the screw (BB) and the cap (II).
FIXED PANEL INSTALLATION
1
Φ3mm
1/8in
2
Φ6mm
1/4in
II
CC
4
II
BB
GG
6
5
N
P
3
O