Jacuzzi ERIKA 48 - Page 13

13
1. Completely remove the support bar. Place the support bar’s anchor (D) back on its wall mark, then mark its center
on the wall.
2-3. Drill a hole on the center marks with a ø8mm (5/16in) drill bit and insert the wall anchors (FF) using a rubber
mallet.Fixthecenterttingonthesupportbar’sanchor(D)usingthescrews(HH).
4Slideagaintheauxiliaryroller(E),2xedpanel’sbrackets(G)andthesupportbar’sanchor(D)ontothesupportbar
(F).Thenxthesupportbartoxedpanel(C)bythe2xedpanel’sbrackets(G).
5. Fix the support bar’s anchor (D) to wall.
SUPPORT BAR INSTALLATION
D
1
KK
3
FF
HH
5
D
D
Φ8mm
5/16in
2
4
C
G